Network Working Group                                         R. Housley
Request for Comments: 3874                                Vigil Security
Category: Informational                                   September 2004
                A 224-bit One-way Hash Function: SHA-224
Status of this Memo
   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.
Copyright Notice
   Copyright (C) The Internet Society (2004).
Abstract
   This document specifies a 224-bit one-way hash function, called
   SHA-224.  SHA-224 is based on SHA-256, but it uses a different
   initial value and the result is truncated to 224 bits.
1.  Introduction
   This document specifies a 224-bit one-way hash function, called
   SHA-224.  The National Institute of Standards and Technology (NIST)
   announced the FIPS 180-2 Change Notice on February 28, 2004 which
   specifies the SHA-224 one-way hash function.  One-way hash functions
   are also known as message digests.  SHA-224 is based on SHA-256, the
   256-bit one-way hash function already specified by NIST [SHA2].
   Computation of a SHA-224 hash value is two steps.  First, the SHA-256
   hash value is computed, except that a different initial value is
   used.  Second, the resulting 256-bit hash value is truncated to 224
   bits.
   NIST is developing guidance on cryptographic key management, and NIST
   recently published a draft for comment [NISTGUIDE].  Five security
   levels are discussed in the guidance: 80, 112, 128, 192, and 256 bits
   of security.  One-way hash functions are available for all of these
   levels except one.  SHA-224 fills this void.  SHA-224 is a one-way
   hash function that provides 112 bits of security, which is the
   generally accepted strength of Triple-DES [3DES].
   This document makes the SHA-224 one-way hash function specification
   available to the Internet community, and it publishes the object
   identifiers for use in ASN.1-based protocols.


Housley                      Informational                      [Page 1]

RFC 3874        A 224-bit One-way Hash Function: SHA-224  September 2004
1.1.  Usage Considerations
   Since SHA-224 is based on SHA-256, roughly the same amount of effort
   is consumed to compute a SHA-224 or a SHA-256 digest message digest
   value.  Even though SHA-224 and SHA-256 have roughly equivalent
   computational complexity, SHA-224 is an appropriate choice for a
   one-way hash function that provides 112 bits of security.  The use of
   a different initial value ensures that a truncated SHA-256 message
   digest value cannot be mistaken for a SHA-224 message digest value
   computed on the same data.
   Some usage environments are sensitive to every octet that is
   transmitted.  In these cases, the smaller (by 4 octets) message
   digest value provided by SHA-224 is important.
   These observations lead to the following guidance:
   *  When selecting a suite of cryptographic algorithms that all offer
      112 bits of security strength, SHA-224 is an appropriate choice
      for one-way hash function.
   *  When terseness is not a selection criteria, the use of SHA-256 is
      a preferred alternative to SHA-224.
1.2.  Terminology
   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [STDWORDS].
2.  SHA-224 Description
   SHA-224 may be used to compute a one-way hash value on a message
   whose length less than 2^64 bits.
   SHA-224 makes use of SHA-256 [SHA2].  To compute a one-way hash
   value, SHA-256 uses a message schedule of sixty-four 32-bit words,
   eight 32-bit working variables, and produces a hash value of eight
   32-bit words.
   The function is defined in the exact same manner as SHA-256, with the
   following two exceptions:
      First, for SHA-224, the initial hash value of the eight 32-bit
      working variables, collectively called H, shall consist of the
      following eight 32-bit words (in hex):



Housley                      Informational                      [Page 2]

RFC 3874        A 224-bit One-way Hash Function: SHA-224  September 2004
         H_0 = c1059ed8               H_4 = ffc00b31
         H_1 = 367cd507               H_5 = 68581511
         H_2 = 3070dd17               H_6 = 64f98fa7
         H_3 = f70e5939               H_7 = befa4fa4
      Second, SHA-224 simply makes use of the first seven 32-bit words
      in the SHA-256 result, discarding the remaining 32-bit words in
      the SHA-256 result.  That is, the final value of H is used as
      follows, where || denotes concatenation:
         H_0 || H_1 || H_2 || H_3 || H_4 || H_5 || H_6
3.  Test Vectors
   This section includes three test vectors.  These test vectors can be
   used to test implementations of SHA-224.
3.1.  Test Vector #1
   Let the message to be hashed be the 24-bit ASCII string "abc", which
   is equivalent to the following binary string:
      01100001 01100010 01100011
   The SHA-224 hash value (in hex):
      23097d22 3405d822 8642a477 bda255b3 2aadbce4 bda0b3f7 e36c9da7
3.2.  Test Vector #2
   Let the message to be hashed be the 448-bit ASCII string
   "abcdbcdecdefdefgefghfghighijhijkijkljklmklmnlmnomnopnopq".
   The SHA-224 hash value is (in hex):
      75388b16 512776cc 5dba5da1 fd890150 b0c6455c b4f58b19 52522525
3.3.  Test Vector #3
   Let the message to be hashed be the binary-coded form of the ASCII
   string which consists of 1,000,000 repetitions of the character "a".
   The SHA-224 hash value is (in hex):
      20794655 980c91d8 bbb4c1ea 97618a4b f03f4258 1948b2ee 4ee7ad67




Housley                      Informational                      [Page 3]

RFC 3874        A 224-bit One-way Hash Function: SHA-224  September 2004
4.  Object Identifier
   NIST has assigned an ASN.1 [X.208-88, X.209-88] object identifier for
   SHA-224.  Some protocols use object identifiers to name one-way hash
   functions.  One example is CMS [CMS].  Implementations of such
   protocols that make use of SHA-224 MUST use the following object
   identifier.
      id-sha224  OBJECT IDENTIFIER  ::=  { joint-iso-itu-t(2)
                      country(16) us(840) organization(1) gov(101)
                      csor(3) nistalgorithm(4) hashalgs(2) sha224(4) }
5.  Security Considerations
   One-way hash functions are typically used with other cryptographic
   algorithms, such as digital signature algorithms and keyed-hash
   message authentication codes, or in the generation of random values.
   When a one-way hash function is used in conjunction with another
   algorithm, there may be requirements specified elsewhere that require
   the use of a one-way hash function with a certain number of bits of
   security.  For example, if a message is being signed with a digital
   signature algorithm that provides 128 bits of security, then that
   signature algorithm may require the use of a one-way hash algorithm
   that also provides the same number of bits of security.  SHA-224 is
   intended to provide 112 bits of security, which is the generally
   accepted strength of Triple-DES [3DES].
   This document is intended to provide the SHA-224 specification to the
   Internet community.  No independent assertion of the security of this
   one-way hash function is intended by the author for any particular
   use.  However, as long as SHA-256 provides the expected security,
   SHA-224 will also provide its expected level of security.
6.  References
6.1.  Normative References
   [SHA2]      Federal Information Processing Standards Publication
               (FIPS PUB) 180-2, Secure Hash Standard, 1 August 2002.
   [STDWORDS]  Bradner, S., "Key words for use in RFCs to Indicate
               Requirement Levels", BCP 14, RFC 2119, March 1997.







Housley                      Informational                      [Page 4]

RFC 3874        A 224-bit One-way Hash Function: SHA-224  September 2004
6.2.  Informative References
   [3DES]      American National Standards Institute.  ANSI X9.52-1998,
               Triple Data Encryption Algorithm Modes of Operation.
               1998.
   [CMS]       Housley, R., "Cryptographic Message Syntax (CMS)", RFC
               3852, July 2004.
   [NISTGUIDE] National Institute of Standards and Technology.  Second
               Draft: "Key Management Guideline, Part 1:  General
               Guidance."  June 2002.
               [http://csrc.nist.gov/encryption/kms/guideline-1.pdf]
   [X.208-88]  CCITT Recommendation X.208: Specification of Abstract
               Syntax Notation One (ASN.1). 1988.
   [X.209-88]  CCITT Recommendation X.209: Specification of Basic
               Encoding Rules for Abstract Syntax Notation One (ASN.1).
               1988.
7.  Acknowledgments
   Many thanks to Jim Schaad for generating the test vectors.  A second
   implementation by Brian Gladman was used to confirm that the test
   vectors are correct.
8.  Author's Address
   Russell Housley
   Vigil Security, LLC
   918 Spring Knoll Drive
   Herndon, VA 20170
   USA
   EMail: housley@vigilsec.com













Housley                      Informational                      [Page 5]

RFC 3874        A 224-bit One-way Hash Function: SHA-224  September 2004
9.  Full Copyright Statement
   Copyright (C) The Internet Society (2004).
   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.
   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/S HE
   REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE
   INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR
   IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
   THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the IETF's procedures with respect to rights in IETF Documents can
   be found in BCP 78 and BCP 79.
   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.
   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.
Acknowledgement
   Funding for the RFC Editor function is currently provided by the
   Internet Society.





Housley                      Informational                      [Page 6]